203562
37
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 4
Error Codes
25. Error Codes
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
Error Code
Possible Causes
Corrective Action
“Er”, “dS”
: Voltage
configuration error
The control has the incorrect voltage
dipswitch setting.
There is a disconnect power fail signal
at H2 connection on output control
board.
The dipswitch setting must be corrected
To clear this error the machine must be
powered down. Reset dipswitch to the correct
voltage. Correct wiring issues.
“Er”, “dr”:
Drain Error,
control sensed water in the tub
at the end of the cycle
Restriction in the tub to pump hose,
drain hose blockage in the pump
Clear restriction from hoses
Replace the pump
To clear this error the machine must be
powered down.
“Er”, “FL”:
Fill Error, the
desired fill level was not
reached within 30 minutes
Water supply faucet closed
Kinked or twisted fill hoses
Filter screens plugged
No voltage from output board to the
water valve (refer to appropriate
schematic)
Low water pressure
Open Faucet
Straighten fill hoses
Clean or replace filter screens
Check for voltage (refer to serial plate) from
the output board to the water valves, and if
voltage is present at output board, then check
for voltage (refer to serial plate) at the water
valve. If there is voltage (refer to serial plate) at
the water valve, then replace the mixing valve.
Correct water pressure to 20-120 psi
(138-827 kPa).
To clear this error the machine must be
powered down.
“Er”, “oF”:
Overflow error, the
control was not able to lower the
water level within 5 minutes.
Leaky water valve
Possible Blockage in the pressure hose
Possible air leak in the pressure hose
Check the inlet valve
Clear blockage in pressure hose
Replace Hose if leak is found
To clear this error the machine must be
powered down.
“Er”, “PS”:
The control did not
detect a valid water level input
from the pressure sensor for 30
seconds
The sensor harness is not connected to
the front end control
The sensor harness is damaged, or has a
break in the wire.
The pressure tube, or hose has a
blockage
Ensure that the sensor harness is plugged into
the front end control
Replace the sensor if the harness is damaged
Clear any blockage to the pressure tube or bulb
To clear this error the machine must be
powered down.
