22
203562
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Troubleshooting
13. Cycle Does Not Advance
Cycle does not advance.
Is pause part
of normal
operation?
Cycle is designed to
pause during fill steps
when going from
agitate to spin and
during soak steps
(soak LED blinks).
Allow completion
of those steps. Some
cycles (delicate) have
additional pauses.
Refer to diagram for
information on time
required.
Yes
Is lid
open?
Close lid. Lid
MUST be closed
any time the
washer is set to
agitate or spin.
Yes
Washer
will not fill?
Cycle pauses
until pressure
switch is
satisfied.
TLW460S
No
Has washer
drive motor
over loaded
and motor
thermal
overload been
tripped?
Control is designed
to stop under
these conditions.
Motor thermal
proctor reset time
may vary
depending upon
the reason for
washer overload,
however, it should
reset within 15
minutes. Check to
ensure washer
was not
overloaded with
clothes.
Yes
Is circuit breaker
to washer tripped,
disconnecting
power to washer?
Reset circuit
breaker.
No
Yes
Control is designed to
pause when going
from spin into rinse
to allow the washtub
to stop spinning
before filling. Make
sure cycle has
advanced into fill
portion of rinse
cycle.
No
Yes
No
Is there broken,
loose or incorrect
wiring?
Refer to
appropriate
wiring diagram.
Yes
Washer
will not fill?
No
Yes
Is washer
siphoning
during rinse
fill?
Install siphon
break kit, Part
No. 562P3.
No
No
Yes
Is
Lid Switch
operative?
Replace switch.
No
Yes
TLW460S