TMB2243N_SVG
2
1
8
7
6
5
4
3
1.
Trunnion Housing
2.
Junction/Contactor Box
3.
Vertical Trunnion Channel
4.
Cylinder Pulley
5.
Drive Guard
6.
Exhaust Thimble
7.
Motor
8.
Motor Bracket
Figure 8
3.
Remove the drive belts. Refer to
Figure 8
.
4.
Remove the cylinder pulley and shaft key.
5.
Pull the cylinder out through the front of the tumble dryer.
Refer to
Figure 7
.
6.
To ensure proper cylinder balance for reassembly, mark each
channel’s original location on cylinder head and number of
shims for each channel before removal. Refer to
Figure 9
.
7.
Remove the complete idler assembly.
8.
Remove the trunnion housing. Refer to
Figure 8
.
9.
Disconnect the motor harness(es).
TMB2015K_SVG
4
5
6
2
3
7
1
1.
Number of Shims for this Channel
2.
Cylinder Head
3.
Trunnion
4.
Channel Identifier
5.
Shims
6.
Channel Location
7.
Number of Shims for this Channel
Figure 9
10.
Remove the motor(s) and motor bracket(s). Refer to
Figure
8
.
11.
Unbolt and remove the two vertical trunnion channels.
12.
Remove the junction/contactor box. Refer to
Figure 8
.
13.
Remove the exhaust thimble.
14.
The gas supply line may require removal if it extends past the
rear panel. If so, disconnect the union located between the gas
and shutoff valves and remove the assembly out through the
front of the tumble dryer.
15.
Remove the tumble dryer from the crate base and slide it
through the door, sideways.
16.
Refer to the appropriate service video, installation manual and
wiring diagram to reassemble and install the tumble dryer cor-
rectly.
To Reverse the Loading Door
1.
Disconnect power supply to tumble dryer.
2.
Unlock and remove control panel. Remove two control as-
sembly mounting screws from right side. Swing open control
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
27
Part No. 70457901ENR12
Summary of Contents for YU050E
Page 2: ......