TMB2242N_SVG
4
3
1
6
8
7
2
5
NOTE: Shaded areas indicate adjacent structure.
1.
0.5 in. [13 mm] recommended between machines for removal or installation
2.
Allow 2-4 in. [51-102 mm] opening at top of machine to aid in removal or installation. A removable trim piece may be used to
conceal the opening; zero clearance allowed for trim.
3.
4 in. [102 mm] maximum header thickness
4.
Minimum clearance permitted for remainder: 12 in. [305 mm]
5.
Guard
6.
Provision for make-up air
7.
24 in. [610 mm] minimum, 36 in. [914 mm] recommended for maintenance purposes
8.
0.25 in. [6 mm] recommended for removal or installation purposes, zero clearance allowed
Figure 2
Position and Level the Tumble Dryer
1.
Remove lint panel door, and unscrew the four shipping bolts
(one at each corner).
2.
Remove tumble dryer from skid.
NOTE: Do not throw bolts away – they are the level-
ing legs.
3.
Remove four nuts from the literature package, and screw one
fully on to each leveling leg.
4.
Screw the four leveling legs (bolts) back into the level adjust-
ing fittings from the bottom.
5.
Slide tumble dryer to its permanent location. Adjust the level-
ing legs until the unit is level, or no more than 0.125 inch
[3.18 mm] higher in the front. Refer to
Figure 3
. Tumble dry-
er must not rock. Lock leveling legs with nuts previously in-
stalled.
NOTE: The front of the tumble dryer should be
slightly higher than the rear (approximately 0.125
inch [3.18 mm]). This will prevent the clothes, while
tumbling, from wearing on the door glass gasket.
IMPORTANT: Keep tumble dryer as close to floor as
possible. The unit must rest firmly on floor so
weight of tumble dryer is evenly distributed.
T483I_SVG
Figure 3
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
23
Part No. 70457901ENR12
Summary of Contents for YU050E
Page 2: ......
