ALLIANCE SWT421, Programming Manual

Page: 14 / 75

12
36198
Signals
There are four options when a signal can be used
during the washer operation. The owner may program
when the signal will sound and at what volume level.
These four options are listed below:
1. End of Cycle Signal
By default, this signal is turned off. If turned on, the
signal sounds for three seconds at the end of a
cycle, at one of the three programmable volume
levels.
2. Signal On Keypad Depression
By default, this signal is set at the lowest volume
level, and sounds for .25 seconds each time a
keypad is pressed. This signal can be programmed
at one of three volume levels.
3. Signal On Coin Drop
By default, this signal is turned off. If turned on,
this signal will sound for .25 seconds each time a
coin is entered at one of the three programmable
volume levels.
4. Signal On Unbalance
By default, this signal is turned off. If turned on,
this signal will sound on for three seconds and off
for two seconds for a total of one minute when the
machine is in the Spin cycle and becomes
unbalanced. The signal will sound until the
unbalance condition is over. The signal can be
programmed at one of the three volume levels.
If the machine becomes unbalanced during the
final three minutes of the final spin cycle, the signal
will not sound.
NOTE: Refer to “Programming the Electronic
Control,” Section VIII, to program signal options.