To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be reconnected
to ensure that the dryer is properly grounded.
WARNING
W001R1
28
505038
20. CONTROL PANEL OVERLAY
(Electromechanical Models)
a. Removal
(1) Unlock control panel. See Figure 5A.
(2) Pull top of control panel away from control
cabinet and lift up. See Figure 5B.
(3) Remove control panel from control cabinet.
See Figure 5C.
(4) Disconnect all wires to components. See
Figure 6.
(5) Remove ground clip holding ground wire to
control panel. See Figure 6.
NOTE: Refer to appropriate wiring diagram when
reconnecting wires.
(6) Loosen setscrew holding control knob to
temperature selector switch shaft and pull
knob off shaft. See Figures 7 or 8.
(7) Remove knurled nut holding temperature
selector switch and lockwasher to panel, then
remove switch and lockwasher. See Figures
7 or 8.
(8) Remove nut holding push-to-start switch
assembly and lockwasher to panel, then
remove switch and lockwasher. See Figures
7 or 8.
(9) Squeeze locking tabs on indicator light, then
pull light out through back of panel. See
Figures 7 or 8.
(10)Remove locknut and lockwasher holding cam
to lock assembly. See Figures 7 or 8.
(11)Remove large locknut holding lock assembly
to control panel frame and overlay, then
remove lock. See Figures 7 or 8.
NOTE: The control panel overlay has an adhesive
backing.
(12)Remove control panel overlay by carefully
peeling it from the control panel frame.
b. Installation
NOTE: Before removing protective backing from
new control panel overlay, make sure overlay fits on
the control panel frame. Switch holes are the locating
guides.
(1) Once the overlay has been fitted to the control
panel frame, carefully peel the protective
backing from either end of the overlay and
firmly press end of overlay into place.
(2) Remove the rest of the protective backing
from the overlay and firmly press the overlay
into place.
(3) Reassemble components on the control panel
frame.
(4) Reinstall control panel frame to control
cabinet.
21. TIMER (Electromechanical Nonmetered
Models)
a. Unlock control panel. See Figure 5A.
b. Pull top of control panel away from control
cabinet and lift up. See Figure 5B.
c. Remove control panel from control cabinet. See
Figure 5C.
d. Disconnect all wires to components. See Figure 6.
e. Remove ground clip holding ground wire to
control panel. See Figure 6.
NOTE: Refer to appropriate wiring diagram when
reconnecting wires.
f. Loosen setscrew holding timer knob assembly to
timer shaft and pull knob off shaft. See Figure 7.
g. While supporting timer, remove screws holding
timer to control cabinet. See Figure 7.
h. Pull timer out through control panel opening as
far as wires will permit.
i. Disconnect wires from timer.
NOTE: Refer to appropriate wiring diagram when
rewiring timer.
j. Remove ground wire from ground terminal on
timer. See Figure 3.
