16
53273
Section 4 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
14. CONTROL PANEL
Refer to Figure 2
a. Models JE2870 and JG2880. Refer to
(1) Pull timer knob off shaft.
(2) Pull fabric switch knob off shaft.
(3) Remove two control panel assembly
screws and lift assembly off control hood
(4) Disconnect all wires to fabric switch, push-
to-start switch and timer.
(5) Remove screws holding end caps to control
panel. Refer to Figure 2 for removal of
components.
b. All models except JE2870 and JG2880. Refer
to Figure 3.
(1) Loosen set screw holding fabric switch
knob to shaft and pull knob off shaft.
(2) Remove two control panel assembly
screws and lift assembly off panel support.
(3) Disconnect all wires for fabric switch,
push-to-start switch and indicator light.
NOTE: Refer to appropriate wiring diagram when
reconnecting wires.
(4) Refer to Figure 3 for removal of
components.
IMPORTANT: Pressing on center of lens when
installing indicator light may break lens. Insert light
into control panel by pressing firmly against trim.
Figure 2
DRY843S
Fabric
Switch
(Electric
Models)
Fabric
Switch
(Gas
Models)
Timer
Start
Switch
Control
Hood
Control
Panel
End
Cap
Hex
Nut
Timer
Knob
Timer
Attaching
Screw
Fabric
Switch
Knob
Panel
Assembly
Screw
