10
202202
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
General Troubleshooting
1. Clicking Noise During Operation on NEWLY Installed Units
If a clicking noise is heard when first starting up a new
topload washer, the noise is related to the belt taking a
temporary “set” around the idler pulley. The set causes
a slight bump in the belt which in turn causes the idler
lever to tap the motor bracket making the clicking
noise. THE BELT DOES NOT NEED TO BE
REPLACED.
To correct this condition please perform the following
break-in procedure:
a. After installing the unit start a fill cycle to
make sure the seals have been lubricated.
b. Stop the fill cycle and place the unit into a
spin cycle.
c. Run the cycle for several minutes until the
belt has warmed up. This will remove the
“set”.
d. Normal use will keep the belt from resetting.
e. For extended periods of non-use (three to four
weeks), this procedure might need to be
repeated.
Summary of Contents for HWNLE2SP111CW01
Page 2: ......
