Error Codes
Display
Description
Cause/Corrective Action
E nF
No Water Flow Er-
ror
If the control does not reach a water level of 4 inches within the programmed time it
may mean the hose to the pressure sensor has a leak or no water is flowing into the
machine. The control will enter Machine Error mode. The control will first drain for
90 seconds and then turn off all outputs and turn on the Machine Error Tone for 15
seconds. To clear this error one of the following must occur: the machine must be
powered down, the Clear Fatal Error Keys must be pressed, or a Clear Fatal Error Net-
work command must be sent.
E oF
Overflow Error
The machine must be powered down, the Clear Fatal Error Keys must be pressed, or a
Clear Fatal Error Network command must be sent. This error is triggered when an un-
safe high water level is detected in the machine and water is unable to drain.
E PS
Pressure Sensor
Error
If the control does not detect a valid water level sensor input for thirty (30) seconds, or
if the Max (Overflow) Fill Level in the control is set to 0 while in Run Mode, Factory
Test Mode, or Overflow Mode, the control will enter Machine Error Mode. The con-
trol will first drain for thirty (30) seconds to get out any water, and unlock the door. To
clear this error one of the following must occur: the machine must be powered down,
the Clear Fatal Error Keys must be pressed, or a Clear Fatal Error Network command
must be sent.
E tr
Trim Error
The machine must be powered down, the Clear Fatal Error Keys must be pressed or a
Clear Fatal Error Network command must be send.
E bb
Broken Belt Error
If a broken belt is ever detected by the control, the control will show error this error
code. To clear this error one of the following must occur: the machine must be pow-
ered down, the Clear Fatal Error Keys must be pressed, or a Clear Fatal Error Network
command must be sent.
E LF
Water Leak Fill
Error
If the water level has raised more than an acceptable amount in a during a water leak
check, the control will save a water leak error status and will continue the machine
cycle. Immediately upon detecting the error the right-most decimal point will be lit.
This lit decimal point can be cleared by pressing the START keypad 3 times in a peri-
od of 5 seconds or by cycling the power to the machine.
Display is dim
Look for loose pins and damaged wires on harness from user control to drive board.
E d
Drive Board Errors
E d 10
Voltage Select Er-
ror
Wrong Input Voltage seen at drive board 120V vs 240V. Dip switch 1 on FEC set
wrong, or possibly water on drive board (let drive dry out and determine cause of wa-
ter). Unpower to clear error. Replace drive board if error persists.
E d 12
Over Voltage AC-
Main Input Error
Machine voltage is too high, check supply voltage to the machine and verify that it is
within machine specifications. Unpower to clear error. Replace drive board if error
persists.
E d 13
Power Fail Dan-
gerous Error
The Neutral Line power input to the machine was seen out of range. Unpower to clear
error. Check for damage in the power supply harness. Replace power supply harness
or drive board if error persists.
Table continues...
Error Codes
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
44
Part No. 805407R6
Summary of Contents for BFNBCASG113TN01
Page 2: ......