Alliance Laundry Systems BFNBCASG113TN01, Original Instructions Manual

Page: 42 / 51

Error Codes
Display Description Cause/Corrective Action
E dL1
Door Lock Non-
Fatal Error If the door fails to lock in twenty (20) seconds in Door Locking Mode after the Drive
has been enabled the control will turn off all outputs and show the error
E dL1
. To
clear this error the door must either open or lock.
E dL2
Door Unlock Non-
Fatal Error If the door fails to unlock in 20 seconds, with a solenoid type door lock, after the drum
has stopped spinning, and all other outputs have been turned off, the control will show
error
E dL2
. To clear this error the door must unlock or open.
E do
Door Opened Dur-
ing A Running Cy-
cle Control detects door open and door locked inputs high. Can be caused by pulling on
door while locked or about to lock. Correct inoperative door locking system. Unpower
machine to clear error.
E Ub1
Non-Fatal Unbal-
ance Error Unable to balance load. Redistribute load and run cycle.
E Ub2
Fatal Unbalance
Error Wires to unbalance switch broken or not connected.
CLoS door
Door Open Indica-
tor Door is not closed during an active cycle. If door is closed, check for improper wiring
or faulty door switch.
Err
Coin Error Invalid coin pulse or inoperative coin sensor. Check coin drop area and remove ob-
structions. If error persists, tampering may have occured. Evaluate security proce-
dures.
E id
Board ID Incorrect replacement control. Replace user control or output board with the correct
part.
E dS
Brownout/Voltage
Configuration Unexpected supply voltage. Check the harness connections between the user control
and the output board. If the user control was replaced, set dip switch #1 to the same
seting as the previous control. If reworking the machine to use a different voltage sup-
ply, the dip switch #1 setting may need to be changed. If the dip switch #1 setting is
changed, power down, power up and try again.
E nr
Drive/Output
Board Not Ready Hardware failure. Try cycling power to machine before replacing output board.
E bS
Drive/Output
Board Shorted Hardware failure. Try cycling power to machine before replacing output board.
En
Machine ID Errors
En 31
Product Byte #1
Mis-Match Product family does not match between the Machine ID Control and Front End Con-
trol. Replace Machine ID Control with one meant for current Front End Control plat-
form.
En 32
Product Byte #2
Mis-Match Machine type does not match between the Machine ID Control and Front End Control
(frontload washer vs. dryer). Replace Machine ID Control and/or front end control
with one meant for current machine type.
Table continues...
Error Codes
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
42 Part No. 805407R6