Error Codes
Display
Description
Cause/Corrective Action
En 33
Product Byte #3
Mis-Match
Control level does not match between the Machine ID Control and Front End Control
(A4 vs. A2). Replace Machine ID Control with a properly configured A level for the
control being attached. Use Factory Test Procedure to determine front end control’s
control level.
En 39
Corrupted Data on
Machine ID Con-
trol
Try cycling power to machine. If error continues, check for damage to Machine ID
Control and harness and/or replace Machine ID Control with a correctly configured
Machine ID Control.
En 3E
Machine control
cannot be config-
ured with the Ma-
chine ID Control
in the machine
Try cycling power to machine. If error continues, check for damage to Machine ID
Control and harness and/or replace Machine ID Control with a correctly configured
Machine ID Control.
En 3F
Cannot communi-
cate with the Ma-
chine ID Control
Try cycling power to machine. If error continues, check for damage to Machine ID
Control and harness and/or replace Machine ID Control with a correctly configured
Machine ID Control.
E Co
Drive/Output
Board Comunica-
tion Error
Communication failure. Power down, power up and try again. If error persists, check
connection between user control and output board, or try replacing the user control or
the output board.
E dr
Drain Error
If the control has the drain error enabled the control will enter Machine Error Mode
when the water height is not below the empty level, after attempting to drain for the
programmable time (default 15 minutes). In the event of a drain error, the control will
turn off all outputs and turn on the Machine Error Tone for 15 seconds.
E Sd
Slow Drain Error
If a slow drain is detected in the Drain step of a running cycle, the machine control
will light the right-most decimal point. The decimal point will remain illuminated af-
ter the slow drain error display has expired, to draw the attention of the owner or at-
tendant. The decimal point can be cleared by pressing the START keypad 3 times in a
period of 5 seconds, or by cycling the power to the machine.
E SL
Suds Lock Error
In the spin steps, if the control determines that there are suds in the machine after run-
ning all programmed Suds Routines, it will display a Suds Lock Error at the end of the
cycle after the door is opened. The control will continue showing this error code until
any key has been pressed or for one minute.
E Ld
Water Leak Drain
Error
Error will display if there is a leak after the door is opened at the End of Cycle for 1
minute. Clears after 1 minute or until a key is pressed. If the water level has dropped
more than an acceptable amount in a during a water leak drain check, the control will
save a water leak drain error status and will continue the machine cycle. Immediately
upon detecting the error the right-most decimal point will be lit. This lit decimal point
can be cleared by pressing the START keypad 3 times in a period of 5 seconds or by
cycling the power to the machine.
Table continues...
Error Codes
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
43
Part No. 805407R6
Summary of Contents for BFNBCASG113TN01
Page 2: ......
