Closing Washer Door
If the door is not closed when the vend price is satisfied,
CLos
and
door
will be displayed until the door is closed. Once door is
closed, the START pad must be pressed to lock door and start the
cycle. If the door does not lock within 20 seconds of being
closed,
EdL1
will be displayed, indicating a door lock error,
while the door continues to try to lock.
If the door locks after 20 seconds, the door lock error will clear
and the cycle will continue normally. The door can be opened to
clear the door lock error as well.
Signals
There are five options when a signal can be used during the
washer operation. These five options are listed below:
1.
End of Cycle Signal
By default, this signal is turned off. If
turned on, the signal sounds for three (3) seconds at the end of
a cycle.
2.
Signal On Keypad Depression
By default, this signal is
turned on and sounds for a quarter of a second each time a
keypad is pressed.
3.
Signal On Coin Input/Card Insertion
By default, this signal
is turned on and will sound for a quarter of a second each time
a coin or card is entered.
4.
Signal for Serial or Network Vending Command
By de-
fault, this signal is turned on for a quarter of a second when
the control receives a valid serial or network vend command.
5.
Signal for Start
By default, this signal is turned on and will
sound one (1) second on and one (1) second off for 10 sec-
onds after vend price has been satisfied.
NOTE: Refer to
options.
Changing Cycles
Cycles can be changed any time before the first fill is complete.
After the first fill is complete, all key presses are ignored.
Selecting a higher priced cycle will pause the cycle until the vend
price has been satisfied. After the vend price has been satisfied,
the cycle will continue with the new selection. If the vend price is
not satisfied within 1 minute, the washer control will go back to
the previously set cycle.
Washer Operation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
13
Part No. 805407R6
Summary of Contents for BFNBCASG113TN01
Page 2: ......
