8
Rockwell Automation Publication 1608S-UM001C-EN-P - November 2018
Chapter 1
About the i-Sense Voltage Monitor
4.
Configure the monitor hardware to match your nominal voltage:
– Find your Nominal Voltage (
Table 4 on page 16
) and record Voltage
Settings and Type.
– Remove the right-side cover (two Phillips screws, top and bottom).
– Verify that plug JP1 is installed correctly for your voltage (
Table 5 on
page 17
).
– Verify that INPUT jumper wires are installed according to your wiring
diagram (
Table 5 on page 17
).
5.
Configure the software and communication (See
Configuration on
page 9
), Perform this step either before or after installation. Needed
supplies:
– A supply of power for the monitor: either (A) the external power supply
(not provided), plugged into the 9V DC jack or (B) AC mains power,
after installation. In normal operation, the monitor is powered by the
mains connection at INPUT_1.
– A laptop personal computer or workstation with Ethernet network card
and web browser.
– Standard Ethernet Cat.-5e cable (an Ethernet cross-over cable is
required for direct connection to older personal computer network-
interface cards).
– Phillips screwdriver.
– Information from your IT department (See
Ethernet Communication
Setup on page 10
).
6.
Install the monitor (See
Installation on page 15
).
7.
A qualified electrician or technician must install in an appropriate
environment (See
Technical Specifications on page 23
).
– Follow the installation instructions.
(See
Communication Connections on page 18
)
8.
Perform step 5, if skipped earlier.
9.
Verify communication: press
♡
to generate a Heartbeat event.
10.
Verify that the event is logged at
www.igrid.com
.
Type:
1608S-3V480K (3-channel)
1608S-6V480K (6-channel)
Wiring:
Voltage
480V
120V
Other
Power Supply Plug JP1:
White (< 250V):
Red (> 250V):
LL
LN
S1: Single-Phase
S2: Split-Phase