All Swim CITYPOOL, Installation And Maintenance Manual

Page: 38 / 43

38
17. Regular pool maintenance
Cleaning of the pool and equipment should be done once a week. This requires:
1. Flush the cartridge filters (1) or replace if necessary (see filter flushing instructions).
2. Skim the leaves floating on the surface of the water with a sieve
3. Using pool cleaning equipment, clean pool bottom and walls if contaminated.
4. Using a handheld photometric tester, measure the chlorine and pH in the pool water.
5. Dosage the required amount of chemicals
6. Technical inspection of swimming pool equipment. Periodic inspections of the piping system
installed in the water supply system are necessary.
7. Inspection of drainage system Well. The water level of the drainage Well must be checked
periodically. Check that the submersible pump is not blocked.
18. Cleaning and replacing cartridge filters
Disassembly of the cartridge filter is only possible when the pump (M1) is switched off. Stop
the pump, open the skimmer (1) housing and remove the cartridges:
Slide the skimmer panel up and remove
Remove the leaves picked up in the basket
Unscrew the two filter cartridges . Rinse the
cartridge filters with a high pressure jet.
Return it back to the skimmer.
High pressure water jet cartridge cleaning:
• Rinse the filter cartridge with a high pressure water jet using a
"Karcher K" series pump (or equivalent)
• Put the washed cartridge back into the skimmer (1).
• Close the cover of the skimmer (1).
• Start the pump (M1).