All Swim CITYPOOL, Installation And Maintenance Manual

Page: 34 / 43

34
POOL STARTUP
12. Power supply and ground circuit connection
The technical pump room of the swimming pool is supplied with 230V, 50Hz AC and must be
connected from the Earth Leakage Circuit Breaker (ELCB) with ≤ 30 mA sensivity (according IEC 60364-
7-702), a minimum short circuit and overload protection proportional to the power cable diameter.
These security modules must be connected to the common panel of the house, in a commonly
accessible location, or integrated in a dedicated electrical cabinet for the pool.
The connection between the pool technical pump room and the electrical box of the house
must be made using a sheathed electrical cable with 3 conductors (Phase / Neutral / Earth) of
sufficient section ensuring maximum power (according to the pool modification):

„City Pool Basic“ modification – cable min 3x1.5mm² and circuit breaker 13A (C13 250 V
AC).

„City Pool Active“ bei „City Pool Fun“ models - cable min 3x2.5mm² and circuit
breaker 20A (C20 250 V AC).
The recommended diameter of the power cable is up to 30m from the common panel. In any
case, it shall be proportional to the distance from the pump room to the common panel. Parameters
given as standard for models with no additional options.
Fig. 32 Outdoors, the cable must be buried in a dich with a PVC or PE sheath to prevent mechanical
damage.
If you want to control the pool light remotely (building, house, gazebo), instal on/off switch
and bring the cabel 2x1.5mm² to the pool control panel (CP) contacts.
According National Electrical Code (NEC) Section 680.26(C), pool water shall be electrically
bonded, not just metals in the structure of the pool itself. The Pool defender compact Anode & Water
Bond installed inline with the pool plumbing. Pool bonding anode protects people, pets and pool
equipment.
Near to the pool set special Grounding rod of 2m. Connect it with cable 1x10mm² through
technical premises to installed Bonding anode (Fig. 33,).