All Swim CITYPOOL, Installation And Maintenance Manual

Page: 32 / 43

32
HOW TO SET A THERMOSTAT :
Pool heating function:

temperature display

temperature control

temperature sensor
error alarm.
Setting the temperature: Press the key “set” for at least 2 seconds, then enter the state of
temperature setting, here the LED displays the setting temperature, then using key or key
can change the parameter
（
the key adds 0.1°C, the key minuses 0.1°C, press and hold it
over 0.5 seconds can add or minus rapidly. After setting, press “set” again, then exit the state of
parameter setting. (The setting temp range is limited by the parameters F13 and F14, please refer
to the advanced operation). Pressing the key “M” in the setting process means cancel and exit, but
the setting value will not be saved.
Advanced Operation: Press the key “M” and hold it for 5 seconds, and if you have set the password,
the LED display the “PAS” to hint you to enter the password, you can use the key and to
enter the password, if the password is correct, the LED will display the parameter code, use “ � ” or
to select the parameter code
，
Pressing the “set” key can make it to show the value of the
parameter after select the parameter, here you use or to set the parameter(pressing the
key and not release can add or minus rapidly), then press the “set” key to return to the state of
showing parameter code after finishing setting. Pressing the key “M” can exit the parameter setting
state when display the parameter code, pressing the key “M” means cancel when in the process of
setting parameter, and the parameter will not be changed. Internal parameter code is showing below: