10
button again to exit Data Hold mode, and
"
"
will
disappear.
Press and hold down this button for about 2 seconds to
enable or disable the backlight. The backlight will turn
off automatically about 10 seconds later after it is turned
on.
5. "
" button
*
Press this button, the meter enters the MAX mode,
and the LCD shows
"
MAX
"
as an indicator, the present
reading on the LCD is the maximum reading of all
readings taken since the mode was activated. Press
this button again, the meter enters the MIN mode,
and the LCD shows "MIN" as an indicator, the present
reading on the LCD is the minimum reading of all
readings taken since the mode was activated.
Press and hold down this button for about 2 seconds
to exit MAX and MIN modes.
6. Function / Range switch
It can be used to select the desired function and range
as well as to turn on or off the meter.
To preserve battery life, set this switch to the
"
OFF
"
position if you don't use the meter.
7. "A" jack
Plug-in connector for the red test lead for current
(
600
mA
*20
A ) measurements.
