DATA TRANSMITTION PROGRAM
operation instruction
SYSTEM REQUIREMENT
To run this application, there are some requirements for the system as follows:
Operating system : Microsoft Windows 98SE/2000/XP/2003/VISTA
Memory: 128MB RAM or more
Monitor: SuperVGA monitor (or better), with the resolution of 800 x 600 or higher
Harddisk space: 10MB (or more) free space
CD-ROM drive
USB port
Mouse or equivalent device
Printer ( optional )
INSTALLATION
1. Place the CD supplied with the meter to the CD-ROM of the computer.
2. Run the drivers.exe application in the CD, the Install Driver dialog box appears. In the Install Driver dialog box, click the "Install" button to install
the USB driver ( It may take several minutes ).
3. Connect the USB data cable supplied with the meter to the terminal on the top of the meter, connect the other end of this USB data cable to the
USB port of the computer. The computer will prompt that a new hardware has been found and the USB driver will be installed automatically.
4. Run the Setup.exe application in the CD , complete the program installation according to the prompts of the computer.
5. Press and hold down the meter's "
" button for about 2 seconds, the symbol
"
RS232
"
appears on the meter's LCD display.
OPERATION INSTRUCTION
After the installation finishes, click EM6000.exe to run it, the following window appears.
In figure 1, the Select a port combo box is for you to select the desired port, it is not necessary for you to do any selection, just press Connect button to
connect to the multimeter ( Tip: The application has the auto-identification function ). To disconnect from the meter, just press this button again.
NOTE: In Windows Vista system, don't disconnect the USB data cable before you disconnect from the meter.
The left-top area is for displaying the measurement readings through a digital play and a analog bar graph. The maximum reading recorded and the
minimum reading recorded are shown below the bar graph at the same time.
The right-top area is a analog meter. The measurement value of this meter is the result of that the number indicated by the needle is multiplied by the
multiplicity factor in the right-top corner of this area.
The right-bottom area is for the chart of the recorded data which are obtained by sampling from the measurement readings.
The left-bottom area is for displaying the currently saved file in which the readings obtained by sampling are shown sequently.
It functions like a needle
type analog multimeter
It functions like a
digital multimeter
Analog bar graph
Data recording area
Chart of the recorded data
Figure 1