26
Note:
For frequency measurement, the display will
show zero or other indefinite values if the
voltage of the input signal is less than about
300mV rms. It is normal.
Note:
When the range switch is in the
"
A
"
range position, you
must use the
"
A
"
jack.
When you use the
"
A
"
jack, the range switch must be in
the
"
A
"
range position.
Measuring Resistance
1. Connect the black test lead to the
"
COM
"
jack and the
red test lead to the
"
V Hz
"
jack (Note:The polarity
of the red lead is positive
"
+
"
) .
2. Set the range switch to
"
"
range, the display
shows
" "
.
3. Connect test leads across the load to be measured.
4. Read the reading on the display.
Note:
1. For resistance above 1M , the meter may take a few
seconds to stabilize reading. This is normal for high
resistance measuring.
2. When the input is not connected, i.e. at open circuit,
"
OL
"
will be displayed for the overrange condition.
