Compressor w/Nailgun
10
Hazard Warnings (cont’d)
Risk of Injury (cont’d)
z
Use only impact grade sockets on an impact wrench.
z
Do not apply excessive force to the tool. Let the tool perform the work.
z
Never point discharge of tool at self or others.
z
Do not pull trigger unless tool contact safety device is against work
surface.
z
Never attempt to drive fasteners into hard surfaces such as steel,
concrete, or tile.
z
Take care to avoid driving a fastener on top of another fastener.
z
Position tool carefully so that fasteners will be delivered to the proper
location.
z
Use only accessories identified by the manufacturer to be used with
specific tools.
z
Maintain the tool with care.
z
Keep a cutting tool sharp and clean. A properly maintained tool, with
sharp cutting edges reduces the risk of binding and is easier to control.
z
Check for misalignment of binding or moving parts, breakage of parts,
and any other condition that effects the tool’s operation. If damaged,
have the tool serviced before using.
z
Use of an accessory not intended for use with the specific tools
increases the risk of injury to persons.
z
Always shut off the compressor, remove the plug from the outlet, and
bleed all pressure from the system before servicing the compressor, and
when the compressor is not in use.
z
Do not operate the unit with the shroud removed.
