Compressor w/Nailgun
30
Finish Nailer (cont’d)
Depth Adjustment
The depth adjustment knob controls the depth to which fasteners are driven
and is preset to a nominal setting. To adjust this setting:
1
Test fire a fastener and check depth.
2
If desired, adjust the depth by rotating the adjustment knob. This knob
has detents every ¼ turn.
3
Rotate the knob clockwise to increase the driving depth
4
Rotate the knob counterclockwise to decrease the driving depth.
5
Test fire another fastener and check depth.
6
Repeat steps 2-6 as necessary to achieve desired results.
The amount of air pressure required varies depending on the depth setting.
Determine the lowest setting that will consistently perform the job at hand.
Air pressure in excess of that required can cause premature wear and/or
damage to the tool.
A rubber nose cushion is provided to reduce marring of the work surface.
You can remove this cushion to provide increased driving depth for toe-
nailing applications.
WARNING! DISCONNECT TOOL FROM AIR SUPPLY BEFORE
REMOVING OR REINSTALLING RUBBER CUSHION.
