27
9
Reverse TX/RX
TX frequency turns to RX frequency & RX
frequency changes to TX frequency. The
signaling will also be reversed if CTCSS/DCS
signaling exited in this channel.
In standby,press
1.
,then press
,LCD displays “REV—OF”.
Press [
2.
/
] to select the desired value.
ON:Enable Frequency Reverse
OFF:Disable Frequency Reverse
Press number keys to confirm and exit.
3.
In corresponding mode,press
then press
key to enter into
scanning.
In scanning mode,press
/
to change scan direction.
Busy Channel Lockout
BCLO is to disable transmitting while RX signal is received. Once the
channel is busy and you press PTT, the radio will beep as warning and
get back to receiving.
In standby,press
1.
,then press
to enter into Busy Channel
Lockout.
Press [
2.
/
] to select the desired value.
BU: Enable BCLO, Carrier lockout, transmitting is inhibited when
current channel receives a matching carrier;press [PTT] to emit error
voice prompt.
RL: Enable BTLO, transmitting is inhibited when current channel
receives a matching carrier but dis-matching CTCSS/DCS.press
[PTT] to emit error voice prompt It can transmit in any receiving
status.
OFF: Busy channel lockout is disabled.
Press number keys to confirm and exit.
3.
This function can be temporarily used in channel mode. Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.
Frequency/Channel scan
Scan Skip
When first bit of Exa byte in frequency displays "F",it
indicates 5Tone function enable.
This function can be temporarily used in Channel mode . Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.
This function can be temporarily used in Channel mode . Once
the radio is turned off or switched to another channel, the
temporary setting will be erased and back to initial settings.
In Channel mode,press
then press
,decimal point displayed
between frequency's ten digit and unit digit,it means current channel is
scan skip. Repeat above operation to set scan or scan skip in current
channel.
decimal point displayed between frequency's ten digit and unit
1.
digit,it means current channel is scanned skip.
decimal point is not displayed between frequency's ten digit and
2.
unit digit,it means current channel is scanned.
