11
In standby, press key or Microphone's
key until appear , this indicates current
frequency in Memory mode. Repeat above
6
PWR KEY
Dial
Frequency
decrease
Frequency
increase
Min
Volume
Max
Volume
Basic Operations
Switching The Power On/Off
Adjusting The Volume
Switch between VFO and MEMORY mode
Adjusting Frequency/Channel THROUGH SELECTOR KNOB
Receiving
ADJUSTING SQUELCH LEVEL
According to the option selected during
installation, press the
switch or turn the
ignition key to ACC (speed up) or ON (startup)
position to power on. Press the
key for 1s or
turn the ignition key to OFF position to turn off.
A squelch eliminates white-noise (the background noise when a signal
is not received). Higher level settings will keep the squelch "closed” more
tightly for quieter monitoring, but weak signals will not be heard. Lower
settings allow weaker signals to "open” the squelch but noise may also
cause it to open. By rotating the SQL knob, adjust the squelch level to
the desired level.
Under frequency (VFO) mode, you can
1.
change the current frequency to the
desired one through selector knob; Turn
clockwise to increase frequency; turn
counterclockwise to decrease. Every
click will increase or decrease one step.
Press
MHz
key, the KHz order digits will
Turn the VOL knob clockwise to increase
the audio level, counterclockwise to decrease.
Press and hold MONI key to hear a white-noise to set the proper audio level.
5k, 6.25k, 8.33K,10k, 12.5k, 20k, 25k, 30k and 50k .
operation to switch between Frequency mode
(VFO) and Memory mode.
be masked. In this status, turn selector knob or Microphone
[
/
] key will increase or decrease frequency quickly
by 1MHz step.
Under channel mode, you can change the current channel to the
2.
desired one through selector knob, clockwise turn to the forward
channel, anticlockwise turn to the backward channel. In relative
Operating mode, Microphone's [
/
] key has the same
function for adjusting frequency and channel.
Transmitting
Press and hold
MONI
key or press MIC's
key to monitor for a while
to confirm the channel desired is not busy.
Release
MONI
or press Mic's
key to return standby status,Then press and hold [PTT] key to speak
into microphone.
Select the desired receiving frequency or browse frequencies to listen to
ongoing communications. The S-meter shows
relative signal strength between BUSY and
5th segment when the transceiver detects an
incoming signal.
