15
Press
1.
key until LCD displays
icon, then press
TS/DCS
key until, LCD
displays icon. Now keypad lockout
function is valid.
This will automatically transmit pre-programmed and stored DTMF
tones. It is necessary to program Auto-dialer tones in advance to operate
this feature.
While pressing and holding
1.
key,
press
MONI
key to display the current
battery voltage.
Repeat above operation to exit.
2.
means transmitting frequency lower than receiving frequency.
Turn selector knob or Mic's [
5.
/
] key to change offset
frequency in accordance with the step setting.
Press any key except
6.
and
MHz
key to set and finish setting.
Press
1.
key until the icon displays
on the LCD, then press
MHz
key, LCD
displays offset direction and offset
frequency.
Repeatedly press
2.
MHz
key to select
positive offset and negative offset.
When LCD displays "
3.
" icon, it indicates positive offset, which
means transmitting frequency higher than receiving frequency.
When LCD displays "
4.
" icon, it indicates negative offset, which
7
Repeater receives a signal(UP-LINK) on one frequency and re-
transmits on another frequency(DOWN-LINK). The difference between
these two frequencies is called the offset frequency. If the UP-LINK
frequency higher than DOWN-LINK frequency, the direction is positive, If
it is lower, the shift direction is negative.
Avoiding unintentional operation, this function will lock main keys, all
keys except
MONI
、
and
PWR
key are invalid.
Offset Direction and offset frequency setup
KEYPAD LOCKOUT
Current Voltage ENQUIRY
Auto-Dialer Setup
In voltage display mode, all functions and channel or frequency
selection are invalid. The displaying value is indicative and only for
reference purposes.
This function will display Current Battery Voltage.
Repeat above operation,
2.
icon disappears, indicating keypad
lockout function is invalid.
Under channel mode,this operation can be temporarily available.
Once the radio is turned off or switched to another channel,the
temporary setting will be erased.
While pressing and holding
1.
key, press
TS/DCS
key to enter
the auto-dialer enquiry mode, LCD displays current default data
and current group displayed on left. If no data in current group,it
shows"EMPTY".
Turn selector knob to choose group
2.
you wish to edit. Up to 16 Auto-dialer
memories are available.
Press
3.
MONI
key to program the DTMF
you wish to transmit automatically.
The display scrolls when the 7th digit
4.
is entered. The numbers 0-9, --, A-D,
*
and # can be stored up to a total of
23 digits.
