Steps
1.
Slide the radiator and fan assembly into the radiator and fan cage.
NOTE: Ensure that the hoses are facing the front of the system
2.
Align the screw holes on the processor cooler with the screw holes on the system board.
3.
Align the screw holes on the VR heat sink with the screw holes on the system board.
4.
Tighten the two captive screws that secure the VR heat sink to the system board.
5.
In the sequential order (as indicated on the processor cooler), tighten the four captive screws that secure the processor cooler
to the system board.
NOTE: If your are using an electric screwdriver, torque the screws at 6.9 +/-1.15 kilogram-force centimeter (6 +/-1
pound force inch).
6.
Connect the processor-cooling assembly cables to the system board.
7.
Replace the four screws (#6-32) that secure the radiator and fan assembly to the chassis.
8.
Rotate the power-supply unit cage towards the chassis.
9.
Slide the power-supply unit cage release latches towards the locked position.
Next steps
1.
2.
.
3.
.
4.
.
5.
Follow the procedure in
After working inside your computer
.
39
Summary of Contents for Aurora R9
