Steps
1.
Lay the computer on the right side.
2.
Slide the power-supply unit cage release latches to the unlock position.
3.
Lift the power-supply unit cage and rotate the power-supply unit cage away from the chassis.
4.
Push the securing clips away from the memory module.
5.
Grasp the memory module near the securing clip, and then gently ease the memory module out of the memory-module slot.
NOTE: Repeat step 5 to step 6 to remove any other memory modules installed in your computer.
CAUTION: To prevent damage to the memory module, hold the memory module by the edges. Do not touch the
components on the memory module.
Installing the memory modules
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the memory modules and provides a visual representation of the installation
procedure.
44
Summary of Contents for Aurora R9
