Algas SDI ZIMMER, Operation & Maintenance Manual

Page: 14 / 48

13
Preparing the site
When preparing your site, consider local setback limitations for your
desired storage container(s). Also, consider points of
ingress/egress and other openings into buildings, including any air
intakes. The
ZIMMER
vaporizer is explosion-proof, which means
that it can be mounted next to, on, or near the storage container(s).

For portable applications, the ZIMMER (up to 50 kg/hr model)
can be mounted on the storage container. Make sure the mount
touches the vessel in as small an area as possible to avoid
corrosion on the vessel surface.

For stationary applications mount the
ZIMMER
on a wall or
support near the container(s) or on the container (up to 50 kg/hr
model) by using the tank mount kit.
Materials you may need for installation
♦
Storage tank, or cylinder(s) with liquid withdrawal valve(s) also
called “dip tube(s)”, are required.
♦ Excess flow valve(s).
♦ Manifold piping if using multiple cylinders.
♦ Inlet isolation valve with hydrostatic relief valve approved for
liquid LP Gas service (included with
Algas-SDI P/N 80892
) .
♦
Piping components including forged steel union or removable
compression/flare fittings.
♦ SCH 80 pipe for liquid service, or approved tubing and fittings.
♦
Inlet strainer with No.40 mesh screen (in
Algas-SDI P/N 80892)
♦
Outlet regulator with high temperature Fluorocarbon elastomer
(Viton) seat, ( Algas-SDI P/N 80890 ) (Outlet Range 0.21 – 2.10
bar [3-30 psig]).
♦
Outlet isolation valve approved for LP Gas vapor service
(included with
Algas-SDI P/N 80892
).
♦
Wall mount kit up to model Z50. ( Algas-SDI P/N 80885 ).
♦
Electrical disconnect switch (See Electrical Specifications in
Appendix).
♦ Metal Terminal box use Algas-SDI P/N 80895 (Div 1) and
P/N
80896 (Ex) for models up to 50kg/hr.
♦
Wire to connect your
ZIMMER
. Wire type will be determined by
your specific voltage, current and wiring conditions.