21
Eve Single manual | Version 4.2 | December 2021
ENGLISH
4. COMMISSIONING THE CHARGING STATION
4.1 Safety instructions before use
Follow the safety instructions below before commissioning
your charging station:
1.
Make sure the charging station is properly connected
to the power supply as described in this manual.
2.
Make sure the distribution of the power supply is
separately protected by an appropriate breaker
(automatic or fuse cartridges)
3.
Make sure the charging station is installed in
accordance with this manual.
4.
Make sure the casing is always closed during
normal operation.
5.
Make sure the charging cable is not twisted and that
the cable, plug and casing do not have any damage.
4.2 Commissioning S-line models
Turn on the local power supply. The charging station will
run self diagnostics.
The following steps will occur within a few seconds:
1.
The output is tested:
- Testing locks (models with socket)
- Testing internal relays: you will hear these click
2.
The LED will flash red 3 x; 1 x slowly, 2 x briefly.
3.
The LED will turn off. Your Eve Single is now ready for
use. If the charging station is set to connect with the
management system, it will do so instantly and
automatically.
4.
If desired, the charging station can be configured
further. Use the Service Installer software package
to gain access.
5.
Have you had the charging station configured for
Smart Charge functionality? If so, check the settings
with the Service Installer application to optimally
configure the charging station for the local situation.
More information is available in Appendix B.
4.3 Commissioning Pro-line models
Turn on the local power supply. The charging station will
run self diagnostics. The following steps will occur within
a few seconds:
1.
The output is tested:
- Testing locks (models with socket)
- Testing internal relays: you will hear these click.
2.
The display will illuminate briefly.
3.
The display turns on and displays the message
'Charging point is powering up'.
4.
The display will show the start screen, recognisable
by the logo on the screen.
5.
The Eve Single Pro-line is now ready for use. If
the charging station is set to connect with the
management system, it will do so directly and
automatically.
6.
If desired, the charging station can be configured
further. Use the Service Installer software package
to gain access.
7.
Have you had the charging station configured for
Smart Charge functionality? If so, check the settings
with the Service Installer application to optimally
configure the charging station for the local situation.
More information is available in Appendix B.
4.4 Configuring the charging station with Service
Installer (application)
REMARK
Before installing the charging station, make sure you have a
user account and are using the newest version of the Ser-
vice Installer application. Click on "Sign up for an account".
Note that account creation may take several working days.
Connect the charging station to your laptop with an
Ethernet cable (UTP).
Summary of Contents for Eve Single Pro Series
Page 1: ...Eve Single Manual Handleiding Handbuch Manuel K ytt opas S line Pro line...
Page 2: ......
Page 34: ......