Alfa Network Color Tester, Technical Manual

Page: 38 / 45

Technical Manual
– Color Tester
38
TROUBLE SHOOTING EN
ERROR
CODES
ERROR
DETECTED
ERROR
DESCRIPTION
TROUBLESHOOTING
219
TIMEOUT_PLUG_COVER1
Capping Station 1 MAB
communication time-out
(detected on the MAB side)
Check the SCCB power supply wiring and
replace it if damaged. Check the RS485
communication connector, and visually
check the board hardware. If damaged,
replace the CAPPING 1 Slave board
220
TIMEOUT_PLUG_COVER2
Capping Station 2 MBA
communication time-out
(detected on the MAB side)
Check the SCCB power supply wiring and
replace it if damaged. Check the RS485
communication connector, and visually
check the board hardware. If damaged,
replace the CAPPING 2 Slave board
221
NO_CONTAINER_AFTER_CAPPING
No can after Capping at the end
of Dispensing (Photocell NOT
engaged)
Check that the can is NOT jammed in
Capping position
222
MOVE_X_AXIS_HOME_POS_ERROR
Loss of steps: deviation upon
the detection of X AXIS slave
HOME position
Verify the cleanliness of rack, splicing
device and sensors, and remove any
residues if necessary. Verify the integrity of
the motor and replace it if deterioration is
encountered. If any mechanical parts are
damaged or jammed on rack teeth and
splicing device, remove or change the
mechanical parts in question.
Verify the electrical connections and
change them if damaged. Check the
photocell sensors and reposition them or
change them if damaged.
223
MOVE_Y_AXIS_HOME_POS_ERROR
Loss of steps: deviation upon
the detection of Y AXIS slave
HOME position
Verify the cleanliness of rack, splicing
device and sensors, and remove any
residues if necessary. Verify the integrity of
the motor and replace it if deterioration is
encountered. If any mechanical parts are
damaged or jammed on rack teeth and
splicing device, remove or change the
mechanical parts in question.
Verify the electrical connections and
change them if damaged. Check the
photocell sensors and reposition them or
change them if damaged.
224
MOVE_X_AXIS_OVER_POS_LIMIT_ERRO
R
Maximum number of steps
carried out by the X AXIS slave
without encountering the END
photocell
Check the correct operation of the END
photocell, any folding of the flag, or the
presence of an obstacle along the path of
the X axis SLAVE
225
MOVE_Y_AXIS_OVER_POS_LIMIT_ERRO
R
Maximum number of steps
carried out by the Y AXIS slave
without encountering the END
photocell
Check the correct operation of the END
photocell, any folding of the flag, or the
presence of an obstacle along the path of
the Y axis SLAVE