Alfa Network Color Tester, Technical Manual

Page: 20 / 45

Technical Manual
– Color Tester
20
PROGRAMMING THE ELECTRONIC BOARDS EN
4.2.3. STARTING THE BOOTLOADER
Run BootloaderApp on the PC (the application is in the
folder selected in step 2 of the installation procedure).
The following window will open.
4.2.4. MAB FIRMWARE UPDATE

Check that the software detected the presence of a
MAB ‘Device attached’ (1)

Select the MAB board to be used by pressing the MAB
button (2) ‘Selected target device is now MAB’ +
‘QueryVerify command sent to MAB BOOT LOADER’

Select the Intel HEX file to be programmed, and press
‘Open Hex File’ (3) ‘HEX File Complete’

Proceed with Programming and Verification, by
pressing ‘Program/Verify’ (4) ‘’: wait for the final
message
‘Erase/Program/Verify Completed
Successfully’

If programming is successful,
the ‘MAB’ button
becomes GREEN.