Effective 11/1/07, Revised 1/1/09, Revised 8/1/09
16
Unique
PMO
Plus
®
Series Sanitary Mixproof Valve Instruction Manual
Think
Top
®,
Digital 8-30 or 110 VAC NO/NC
Automation
*) Note
- Terminals 24, 25, 26 and 27 can be used for external seat-lift sensors as well as for any digital input. Always use an external NO
sensor.
- Two external signals can be connected, they are associated with feedback signals 3 (seat-lift 1) and 4 (seat-lift 2). External sensor
must always be a 8-30 or 110 VAC NO 2 wire sensor. Connect ~ common on terminal 26. The signals from the external sensors
are associated as follows: sensor signal on terminal 24 (seat-lift 1) associated with feedback 3 (seat-lift 1), and sensor signal on
terminal 25 (seat-lift 2) associated with feedback 4 (seat-lift 2).
**) Note
Jumper present = NO. The selection NO/NC is done by the jumper. If changing the function a power recycle is necessary.
Note!
Remember to isolate wires that are not in use.
Examples of connecting power supplies
One power for sensor system and solenoid valves:
Two power supplies, one for sensor system and one for the solenoid valves:
E
D
F
C
B
A
A. Digital interface command signals
B. Internal connections to solenoid 1-3
C. Feedback signals to digital interface
D. Jumper connections **)
E. Incoming signals from external sensors
F. Support to external sensors
6. Solenoid 1
7. Solenoid 2
8. Solenoid 3
9. Supply ~
10. Supply ~
11. Solenoid common
Earth
20. Solenoid common
21. Solenoid 1
22.
23.
1. Closed vlave
2. Open valve
3. Seat-lift 1
4. Seat-lift 2
5. Status
12. NO/NC Jumper
13. NO/NC Jumper
24. Seat-lift 1*) “upper” ~
25. Seat-lift 2*) “lower” ~
26. Supply ~ *) com. ~
27. Earth
