4 Installation
4.4
Pump and control panel mounting
Alfa Laval recommends that when mounting the pump and control panel, to use the supervision and direction of a professional
electrician to ensure proper installation and safety precautions are taken.
For installation of the pump, Alfa Laval recommends the following tools and materials:
-
Concrete hammer drill with appropriate drill bits
-
McMaster-Carr vibration-resistant wedge concrete stud anchors (Part number 94475A263) or other equivalent anchor bolts
-
Some type of mechanical hoist
For mounting of the pump follow the recommended steps below:
Step 1
Place the pump into desired position and mark the mounting holes onto the floor. Be sure to take into account the direction of
the flow of the pump so that the suction hose and discharge hose can be properly routed.
Step 2
Move the pump out of the way to allow proper space for drilling.
Step 3
Drill holes where bolt hole locations have been marked onto floor, making sure to drill to the proper depth required for the
selected mounting anchors (2 in. if using the recommended McMaster-Carr Anchors).
Step 4
Install the anchor bolts into the drilled holes and then lower the pump back into position onto the bolts and install the anchor nuts
and washers making sure to tighten the anchor nuts in a star pattern.
NOTE
Over tightening anchor nuts may crack the base of the pump
For mounting of the control panel, Alfa Laval recommends that it be done by a professional electrician according to industry
standards.
9
Summary of Contents for GJ Tote Blast Station
Page 2: ......
