24/30
ALFA IN a.s. ©
www.alfain.eu
activated the JOB choice by the remote control, you can switch between
JOBs.
10. MIG/MAG WELDING MANUAL
1. Choose MAN method (see SETTING THE METHOD OF WELDING).
2. Left display
V10
shows MAN.
3. Left display
V10
shows wire feed speed, right display
V11
shows voltage
or choke.
4. Wire feed speed set by the encoder
V5
.
5. Voltage or choke set by the encoder
V16
.
6. By long-pressing the button
V13
switch settings and screening of voltage
or choke.
7. Press the button
V20
to switch between modes
2T
/
4T
.
8. During welding, the left display
V10
shows measured values of welding
current and the right display
V11
shows voltage.
9. After welding, on the displays will remain measured values (
HOLD
) for 6
s.
10.
If is connected the torch with remote control, on its display is shown
wire feed speed, voltage or choke. With buttons
H6
(UP) and
H7
(DOWN)
set the displayed value, with the button
MODE
swith between functions. If
is activated the JOB choice by the remote control, you can switch between
JOBs.
WELDING VOLTAGE
It is set using voltage encoder
V16.
WELDING CURRENT – GENERAL INFORMATION
Size of the welding current depends on the wire feed speed and voltage.
Characteristic of the curve ("hardness / softness") can be controlled by
correction of the choke.
Approximate setting for the MIG / MAG welding current and voltage corresponds
the empirical relationship U
2
= 14 +0.05 I
2
. According to this relationship, we can
determine the required voltage. When setting the voltage, we expect the decline
in voltage during load. The voltage drop is approximately 4.5-5.0 V at 100 A.
Set the welding current by setting the welding voltage first and then configure
the wire feed speed to the point, where the burning of the arc is ideal.
Please note that the actual settings for ideal arc may vary slightly depending on
the position of the weld material and voltage fluctuations.
