28
2-in-1 Chainsaw with Telescopic Pole
AFTER SALES SUPPORT
e-mail: [email protected]
1300 889 028
MODEL: N
o
.
705156 · 03/2021 · GCS250F
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: [email protected]
1300 889 028
MODEL: N
o
.
705156 · 03/2021 · GCS250F
Cutting with telescopic pole
1. Connect the chainsaw to extension cord. Connect
extension cord to power supply. Before cutting a high
branch, consider all the same points detailed in the
previous section but pay particular attention to the
likely path of the falling branch.
WARNING: Do not stand directly below
a branch being cut. Keep bystanders far
away. Do not stand on a ladder or other
type of unstable support while using
the tool. Do not use the tool near cable,
electrical power or telephone lines. Keep
3m (10’ ) away from all power lines (Fig. Q1
– Q4).
2. Use both hands to grip the pole chainsaw. Use
only designated grip areas when operating pole saw
(Fig R). Use firm grip. Thumbs and fingers must wrap
around pole saw handle and pole.
3. Make sure your footing is firm. Keep feet apart.
Divide your weight evenly on both feet.
4. When ready to make a cut, press the lock-off
button, then fully press the on/off switch (Fig S). This
will turn the pole saw on. Releasing the on/off switch
will turn pole saw off. Make sure the saw is running at
full speed before starting a cut.
5. When starting a cut, place moving chain against
wood. Hold the pole saw firmly in place to avoid
possible bouncing or skating (sideways movement)
of saw.
6. Guide the pole saw using light pressure. Do not
force the pole saw. The motor will overload and can
burn out. It will do the job better and safer at the rate
for which it was intended.
7. Remove the pole saw from a cut with saw run-
ning at full speed. Stop pole saw by releasing trigger.
Make sure chain has stopped before setting pole saw
down.
Q1
Q2
Q3
Q4
R
