22
2-in-1 Chainsaw with Telescopic Pole
AFTER SALES SUPPORT
e-mail: [email protected]
1300 889 028
MODEL: N
o
.
705156 · 03/2021 · GCS250F
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: [email protected]
1300 889 028
MODEL: N
o
.
705156 · 03/2021 · GCS250F
Adjusting the inner pole
The pole saw has a telescoping pole assembly that will extend from 227.8 cm
(89 11/16”) (fully retracted) to 303.3 cm (119 3/8”) (fully extended).
A cam-levered collet is used to hold the pole in position at any extended length.
1. To extend the inner pole (17), loosen the clamping lever (18) by lifting it up.
Pole will slide freely (Fig F1).
2. Pull inner pole section out to desired length of extension (Fig F2).
NOTE:
Only extend pole to minimum length required to reach limb that is
being cut.
3. To lock pole in position, tighten clamping lever (18) by pushing it down to
the original position (Fig F3).
F1
F2
F3
Attaching the shoulder strap
Attach the shoulder strap (39) before operation
when you use the product as a pole saw according
to your requirement.
1. Remove the fixing ring for shoulder strap (40)
from the shoulder strap (39).
2. Remove the screw (d) on the fixing ring with
wrench or tweezers (not supplied) (Fig G1).
3. Attach the fixing ring (40) to the lower telescopic pole (22) (Fig G2).
4. Replace the screw and tighten it with the wrench or tweezers (not supplied)
(Fig G3).
5. Secure the shoulder strap hook of the shoulder strap to the eyelet on the
circle ring (Fig G4).
6. Check if the shoulder strap is correctly attached before operation.
G1
d
