28
Digital Inverter Generator with Pure Sine Wave
AFTER SALES SUPPORT
e-mail: [email protected]
1300 889 028
MODEL: №. XG-KF2000 • 03/2020 • 700069
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: [email protected]
1300 889 028
Digital Inverter Generator with Pure Sine Wave
MODEL: №. XG-KF2000 • 03/2020 • 700069
Air Filter
It is very important to maintain an air filter (18) in proper condition. Damage to
the generator may arise if the filter has:
• Improperly been serviced.
• Dirt and other foreign elements adhering to the filter due to improper
installation and engine wear.
It is recommended the air filter (18) is cleaned every 50 hours (every 10 hours
under dusty conditions).
ALWAYS keep the filter clean at all times.
WARNING:
Ensure the engine is switched off while undertaking this task.
1. Remove the air filter cover (17) on the side of the generator using the
supplied screwdriver (31) by removing (unscrewing) the
4 screws (1 on
each corner)
, in an anti-clockwise direction (Fig X).
2. Remove the air filter (18) by first sliding out the tray (Fig Y).
3. Wash the air filter (18) in hot soapy water and allow to dry.
4. Lubricate the air filter (18) using a small amount of engine oil (SAE 10W-30).
5. Thoroughly squeeze the air filter (18) removing any excess oil.
6. Replace the air filter (18), and re insert the tray.
7. Secure the air filter cover (17) back using the supplied screwdriver (31)
by screwing back in the 4 screws on the side of the air filter cover in a
clockwise direction until secure.
IMPORTANT.
Never run the engine without the air filter element in place.
CAUTION:
Never use fuel or low burning paint solvents to clean the air filter
(18). A fire or explosion could result.
CAUTION:
Ensure the air filter (18) is dry before re fitting.
Replacement air filters
are available from https://
help.tools/ or by calling
Customer Service on
1300 889 028
X.
Y.
