19
August 31, 2018
LINKING V-PAGE STATIONS TO QSYS
Your Q-Sys design must contain the minimum elements to make a V-Page work: The V-Page Plugin, a PA Router,
and your Audio Source. A VP4X can transmit a single digital audio signal via Dante and AES67 stream.
Once your design is ready to be tested simply “Save to Core and Run”
. With your V-Page powered on and the
zone buttons blinking red press and hold buttons 1,2, and 4 until a continuous scan sequence start on your V-Page
unit. Double click on the plugin block and hit Link.
When adding additional V-Page
stations to your system, don’t forget to give the new station a unique ID and IP
address.
Congrats! Your V-Page control has been set and you should be able to test your control functions.
ADDING PREVIOUSLY PROGRAMMED V-PAGE STATIONS TO A NEW DESIGN
If you need to reprogram a V-
Page station, toggle DIP Switch 2 to the “On” then “Off” position. This will reset the
station into Factory Default Mode.
DANTE CONTROLLER SOFTWARE
Dante Controller will allow you to see all your Dante devices within the network, and enable the use of AES67
audio stream. Q-Sys control and AES67 can travel through the same physical cable; however, if Dante audio
stream is preferred a separate Dante I/O card must be installed in your Q-Sys Core system.
You can download the Dante audio network configuration software, Dante Controller, here:
https://www.audinate.com/products/software/dante-controller
This webpage also contains instructions on how to use the application.
AES67 AUDIO CONFIGURATION
Your design should contain an AES67 receiver in order to run digital audio from the V-Page through your design.
An AES67 Receiver should be previously added into the inventory tab by selecting the + sign and choosing an
AES67 Receiver under the Streaming I/O sub menu. Drag and drop into your Q-SYS designer page an AES67
Receiver, connect a wire from Output 1 to Input 1 of the Zone PA router.
