March 23, 2012 • Alcorn McBride ProTraXX User’s Manual • Rev 1.4 •
Page 55
Mute/UnMute/Volume Control
Description:
This command causes the ProTraXX to mute, unmute, or set the volume level of the
specified Channel, Channel Pair, or Channel Group.
Command Bytes:
<v><d>AD
Parameters:
<v>
is one of the following (in ASCII):
M -
Mute
U -
Unmute
T -
Toggle Mute
# -
number between 0(silent) and 10(loudest)
<d>
is either
C
followed by a channel number in ASCII,
P
followed by a channel
pair number in ASCII, or
G
followed by a channel group number in ASCII
Comments:
Channel numbers range from 1 through 16, Channel Pairs from 1 through 8, and
Channel Groups from 1 through 13. Use “*” for All Channels.
Message Response:
R
Examples:
Mute Channel 2.
MC2AD
Unmute Channel Group 1.
UG1AD
Set Volume of Channel 3 to 7/10
7P3AD
Mic In/Aux In Volume Control
Description:
This command sets the input volume level of the ProTraXX’s microphone input and
auxiliary inputs.
Command Bytes:
I<s><g>AD
Parameters:
<s>
is either
L
for the aux inputs or
M
for the microphone input
<g>
is the desired level in dB
Minimum OS Version:
TraXXOS 1.2.3
Comments:
Levels can range from -64 to 24. By default, the input level is set to 0dB. Increasing
the level past 0dB can cause distortion.
Input volume settings will stay active while the unit is powered, and reset to
default(0dB) on boot. You can put the command in your playlist #0 file to
automatically set input level on startup.
Message Response:
R
Examples:
Set Mic Input to -10dB.
IM-10AD
Set Aux Input to +3dB.
IL3AD
