Alcorn Mcbride Digital Video Machine 4, User Manual

Page: 71 / 84

DVM4.INI 63
DVM4.INI
In the MEDIA folder (where you are located by default when you log in via FTP) is located
DVM4.INI . It contains settings that you can use to setup default behavior of the unit on power-up.
Below, you will find an example of this file containing all of the entries and descriptions. All of these
are changed automatically when you send a command to change them via the remote control
interfaces. However, if you wish, you may edit
DVM4.INI manually and reboot the unit for the
settings to take effect.
[GENERAL]
UnitID=1 unit ID – useful when talking to multiple units over UDP broadcast
GroupMode=PEER Grouping Mode – Sets behavior of grouped channels - * see next page
[GEOGRAPHICAL]
Longitude=81 set this if you want sunrise sunset calculations for scheduler to work
Latitude=28 set this if you want sunrise sunset calculations for scheduler to work
TimeZone=-5 set this when you set your time
DSTEnable=1 set this to support Daylight Savings Time
DSTType=usa set this to values like usa, aus, utc. Check UDP table for values
[SCHEDULER]
BootUpDelay=0 Make the scheduler wait this many seconds before beginning.
LogActivity=No Set to 1 to Log scheduler activity
[NETWORK]
IPAddress=192.168.0.254
SubnetMask=255.255.255.0
GWAddress=192.168.0.1 Gateway Address
Password=password FTP login password
[CHANNEL1]
VideoMode=NTSC NTSC, PAL, 720p, 1080i, 480i, 480p, 576i, 576p
Colorspace=Composite Composite, RGB, YUV
Aspect=4:3NORMAL 4:3 Aspect Ratio **see next page
[CHANNEL2]
VideoMode=NTSC
Colorspace=Composite
Aspect=4:3NORMAL
[ETC…]