INSTALLATION MANUAL
30
19.0 ATTACHING THE GPS ANTENNA (IF REQUIRED)
The GPS module (04-000001) is attached separately to the ECU. The GPS
module consists of a cable plug and an antenna with an adhesive strip.
1. Attach the GPS cable plug onto the communication port
at the bottom of the ECU.
2. Run the antenna cable from the ECU to the vehicle
interior.
ATTENTION! The GPS antenna module must not interfere with vehicle operation.
3. Position the GPS antenna in an area of the vehicle
interior that has a direct line of sight with the sky –
preferably on the dashboard.
4. Remove the plastic covering from the adhesive patch at
the back of the antenna, and mount the antenna onto the
surface.
20.0 SEALING CONNECTIONS AND RESTORING THE
VEHICLE
Seal all connections and restore the vehicle only after doing the following:
•
Connecting the ECU, alarm horn and alarm flasher wires (if required)
•
Performing an HS install and ITE transaction
•
Performing post-installation testing
•
Attaching the security enclosure and GPS patch antenna (if required)
ATTENTION!
•
Each connection must be as neat and secure as possible – use solder point
connections and supplied heat shrinks
•
Do not use butt or clip connectors to seal wiring, as this may lead to corrosion
and intermittent power
•
Use supplied, heat shrinks or tamper resistant labels on all solder
connections. Refer to section 24.0 of this manual
•
Use supplied tie wraps to neatly incorporate wires into the
vehicle wire loom. Keep wires away from vehicle components that move,
or that become excessively hot
