Alcatel SPEED TOUCH 710, User Manual

Page: 204 / 254

Introduction
Procedure
18 Maintenance - Speed Touch ToDefaults
204 / 254
3EC 17605 AAAA TCZZA Ed. 02
18.2.3 SwitchtoDefaults
At the back of the AST710 there is a set of DIP switches labeled
"Config".
Via these switches a hardware reset of the
AST710 , the
SwitchtoDefaults , is possible.
Proceed as follows:
1. Make sure your AST710 is turned on.
2. Put DIP switch number 4 in the UP position:
Config Console
You will notice that the PWR/Alarm LED flashes amber.
3. Power cycle the AST710 and wait to allow the POST to end.
The AST710 will come online with manufacturing defaults.
4. Reset the DIP switch in its original position. If not, the
'PWR/Alarm' LED will flash amber as a warning.
5. After a reset to original defaults a reconfiguration of
AST710 's IP address might be necessary. This because the
reset to defaults also resets your AST710 's IP address to its
default value 10.0.0.138.
DIP Switch Position
Leaving the DIP switch in the UP position, will cause unintended
reset to manufacturing defaults !
CAUTION