14
Audio PID- This value should ALWAYS be one value increment of the Video PID that was
entered. Thus if you have set 105 for the Video PID then you should set 106 for the Audio PID.
Press
transmit button on the programmer to send the change through to module.
Audio bit rate – The audio bit rate refers to the number of bits used per unit of playback time to
represent a continuous medium such as audio. There are 10 options for you to choose from.
We generally recommend using 192 or 256 Kbps. The lower the value the poorer the audio
quality will be. The value is also proportional to the bandwidth being used from the modulator
which is displayed below this setting.
Press
transmit button on the programmer to send the change through to module.
The Service bandwidth is indication information and should never exceed 45%. If the Service
BW is higher than 45% you can lower the rate by dropping he Video Bit rate or the Audio bit
rate.
Once you have set all the parameters to your liking press the
button to take you back
into the previous parameters screen that can be seen below.
TS ID- This number needs to be unique to the modulator system. We recommend that this
number coincides with the position of where it sits on base plate. Transport Stream ID number
must not be repeated again on another modulator on the same network.
Press
transmit button on the programmer to send the change through to module.
TS ID number needs to
be unique with each
modulator
Cannot be
changed
