7
6
Installing Barrel Assembly (Fig. 3 & 4)
This caulk and adhesive gun has acces-
sories available for use with sausage
packs and bulk material.
1. Lock trigger or remove battery pack.
2. Press in and hold rod release trigger.
3. Grasp plunger rod handle and pull
plunger rod back until the rod tip is just
inside of tool.
4. Release rod release trigger.
5. Insert barrel nut into back cap (fine
thread) and spacer. Then, thread bar-
rel nut into nose of tool as shown
(Fig. 3).
6. Insert thrust ring into back cap, then
install barrel (Fig. 3). Tighten barrel to
achieve individual swivel preference,
then snug lock ring against back cap.
7. Press rod release trigger and push
plunger rod forward to access the
threads on rod.
8. Install packings onto the rod in order
shown.**
9. To remove barrel tube, reverse procedure.
** Refer to Fig. 3 when using bulk mate-
rial. Refer to Fig. 4 when using sau-
sage packs.
Installing Caulk or Adhesive Tube
1. Lock trigger or remove battery pack.
2. Cut nozzle of tube at an angle and size
per manufacturer's recommendation to
suit the job. A smaller nozzle diameter
requires more force to push the caulk
and reduces battery life.
3. Break inner seal of tube using a long
nail or piece of wire. If the inner seal is
not broken, the caulk material may be
forced out the rear end of the tube
and damage the tool.
NOTE:
Before using a partially filled
tube, remove any hardened material
with a long nail or piece of wire.
4. Press in and hold rod release trigger.
5. Grasp plunger rod handle and pull
plunger rod back to allow the caulk
tube to fit inside tube holder.
6. Insert caulk tube into tube holder.
7. Push plunger rod handle forward until
the plunger is against the caulk tube.
8. Release rod release trigger.
Packing, Cup
Ejector, Poly
Washer, Large
Washer, 7/8 O.D.
Piston, Concaved
Nuts, 1/4-28
Washer, Small
Nozzle, Plastic Orange
Cap, Front (Ring)
Gasket (Not Shown)
Fig. 4
Fig. 3
Cap, Front
Nozzle
Packing, Cup
Washer, small
Barrel
Lock Ring
Spacer
Cap, Back
Rod
Barrel Nut
Thrust Ring
Washer, Large
Ejector, Conical
Nut, 1/4-28
Gasket (Not Shown)
WARNING!
Always lock trigger or remove
battery pack before changing or
removing accessories. Only use
accessories specifically recom-
mended for this tool. Others may
be hazardous.
Installing Tube Holder Assembly (Fig. 2)
A 10 oz. tube holder is supplied with the
caulk and adhesive gun.
1. Lock trigger or remove battery pack.
2. Press in and hold rod release trigger.
3. Grasp plunger rod handle and pull
plunger rod back until the rod tip is just
inside of tool.
4. Release rod release trigger.
ASSEMBLY
WARNING!
To reduce the risk of injury,
keep hands out of the plunger
area of the tool. Fingers can be
pinched between the tube holder
and the plunger.
Fig. 2
Plunger
Plunger rod
Tube holder
Barrel nut
Frame cap
5. Thread barrel nut attached to tube
holder onto nose of the tool.
NOTE:
The frame cap, barrel nut, and
tube holder are provided pre-assembled.
6. Press rod release trigger and push
plunger rod forward to access the
threads on rod.
7. Thread plunger onto the plunger rod in
order shown (Fig. 2).
8. To remove tube holder, reverse pro-
cedure.
