Alberici HIRA ONE, Operator'S Manual

Page: 8 / 28

8
6. Operation
Two buttons are available: “OK” and “SEL”. The latter allows the user to choose the language he
wants on the display (English, French, German, Italian and Dutch are available. Ask before placing
order for other languages options). This type of operation varies depending on whether the
operation mode is set to A
UTOMATIC
or to M
ANUAL
.
A
UTOMATIC
M
ODE
- when a note or coin is inserted, the credited amount is displayed, and the
control board starts the pay-out by the hopper.
M
ANUAL
M
ODE
- when a note or coin is inserted (or when the value of one token is reached), the
OK button will lit up green . Press the button to receive change coins (tokens). If the machine is set
to Tokens with Bonus, it will be possible to choose what Bonus level must be reached before
getting the tokens. Introduce money until the searched amount is reached, then press the OK button.
WARNING: If there are not enough coins in the hopper to fulfil the whole exchange request, the remaining credit shall
be displayed and retained in memory. Switch off the machine, fill the hoppers, and switch on again: the remaining
credit shall be paid out.
An option is to set the Remaining Credit Menu (see section 7.3.14) so as to cancel the remaining credit - and
at the same time record it in the Accounts menu - by switching the machine off and on again.
7. System configuration
7.1 Default setup
This Money-Change machine is preset by default as follows (unless requested for different setup):
Control Board Parametres Pay-out mode = AUTOMATIC
Bonus = DISABLED
Level sensors = DISABLED
Hopper S11 Parameters
Hopper nr. 1 € 2.00 = ENABLED
Hopper AH4 discriminator [ccTalk]
Preset by default to 0,50 – 1,00 – 2,00 €
BILLYONE Validator [ccTalk] Parameters
€ 5.00 - …. - € 100.00 = ENABLED
AL66 S [ccTalk]coin acceptor Parameters
€ 0.05 - € 0.10 - € 0.20 = DISABLED
€ 0.50 - € 1.00 - € 2.00 = ENABLED
7.2 Restore default configuration
If any variation is made, it will be possible to restore the default configuration as follows:
enter the initial menu, scroll by UP and DOWN keys and choose
RESTORE DEFAULT CONFIGURATION
then press OK; the message
DEFAULT CONFIG
.
RESTORED
will be displayed.
NOTICE: the
RESTORE DEFAULT CONFIGURATION
command resets the default PIN code (0000) .
www.saxxot.de