PX865PE/ PX865P Series
37
Onboard LAN Device
This item allows you to enable or disable the LAN Device. Options: Enabled (default)
、
Disabled
Onboard I/O Chip Setup
PWRON After PWR-Fail
This field will determine whether your system will boot after restoring power after a power failure. If
you select “On”, the system will boot whether or not the system was on before power failure. If you
select “Former-Sts”, the system will be restored to the status before the power failure.
Options: Off (default)
、
On
、
Former-Sts
Power On Function
This option allows you to select a way to power on your computer. Options: Password
、
Hot KEY
、
Mouse Left
、
Mouse Right
、
Any KEY
、
BUTTON ONLY (default), and Keyboard 98
KB Power On Password
This it the password that your system will use as part of the power-on sequence. This field is only
configurable when “Power On Function” is set to “Password”.
Hot Key Power ON
This option allows you to use the Ctrl key along with a hot key (function key) to power on your
system. This field is only configurable when “Power On Function” is set to “Hot Key”.
Options: Ctrl-F1
、
Ctrl-F2…… Ctrl-F12
Onboard FDC Controller
Select “Enabled” if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add-in FDC or the system has no floppy drive, select “Disabled”.
Options: Enabled (default)
、
Disabled
Onboard Serial Port 1/ Port 2
Select an address and corresponding interrupt for the first/ second serial port.
Options: Disabled
、
3F8/IRQ4 (default for port1)
、
2F8/IRQ3(default for port2)
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto
UART Mode Select
This item allows you to select the Infra Red (IR) standard to be used.
Options: Normal (default)
、
ASKIR
、
IrDA
