PX865PE/ PX865P Series
36
IDE Primary / Secondary /Master / Slave UDMA
Ultra DMA 100 functionality can be implemented if it is supported by the IDE hard drives in your
system. As well, your operating environment requires a DMA driver (Windows 95 OSR2 or a third
party IDE bus master driver). If your hard drive and your system software both support Ultra DMA
100, select “Auto” to enable BIOS support. Options: Auto (default)
、
Disabled
***OnChip Serial ATA Setting***
On-Chip Serial ATA
This item allows you to enable or disabled the on-chip serial ATA function.
Options: Disabled (default)
、
Auto
、
Manual
Serial ATA Port0/ 1 Mode
This item allows you to select the Serial ATA device mode for port 0 & 1.
Options: Primary Master (default for Port1)
、
Primary Slave (default for Port2)
、
Secondary Master
、
Secondary Slave
Onboard Device
If you highlight the “INTEL OnChip PCI Device” label and then press the enter key, it will take you
to a submenu with the following options:
USB Controller
This option should be enabled if your system has a USB port installed on the system board. You will
need to disable this feature if you add a higher performance controller.
Options: Enabled (default)
、
Disabled
USB 2.0 Controller
This option should be enabled if your system has a USB 2.0 device installed on the system board.
You will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)
、
Disabled
USB Keyboard Support
Enables support for USB attached keyboards. Options: Disabled (default)
、
Enabled
AC97 Audio
This item allows you to control the onboard AC’97 audio. Options: Enabled (default)
、
Disabled
