8
Setup
Setup
Unpacking
The following items are in the package:
(a) Transceiver’s main body
(b) Rubber ducky antenna
(c) Battery pack NiMH 1,200 mA/h
(d) Standard battery charger composed by two parts:
• Cradle
• AC adapter
(e) Belt clip
(f) User’s guide (this book!)
If something is missing please promptly advise your supplier.
Fitting/removing the antenna
T
o fit the antenna:
1) Locate the antenna terminal (thread MX connector) on transceiver’s
top.
2) Hold the transceiver with one hand and the base (the thicker part)
of the antenna with the other one.
3) Attach the included rubber ducky antenna to the antenna terminal
by turning it clockwise until it is firmly locked. Don’t overtight it.
To remove the antenna do the same described procedure. At step 3
turn the antenna base counterclockwise.
I
Leave the antenna fitted on the radio. You can’t communicate
without it. Moreover, transmitting without the antenna may
damage the TX output final stage. For the same reason use
only the supplied antenna.
2
The supplied antenna is broadband type and covers the whole
spectrum, so it doesn’t need any alignment procedure.
Installing/removing the battery pack
To install the battery pack (please see the figure):
1) Hold the transceiver’s body with one hand and the battery pack
with the other. Put the battery pack onto the metallic back of the
transceiver as shown at approximately 2 cm from its back edge.
back edge
1
2 cm
2
battery
pack
transceiver
4
3
English