AL-KO Robolinho 1150, Manual

Page: 73 / 652

442811_a 73
■
Replace bent cutting blades by original spare
parts from AL-KO.
Worn or bent cutting blades must be replaced.
1. Switch off the appliance with .
2. Put down the appliance with the cutting blades
pointing upwards.
3. Unscrew the fastening screws.
4. Take the cutting blade out of the blade seat.
5. Clean the blade seat with a soft brush.
NOTE The cutting blades are sharpened
along the entire length and can therefore also be
mounted rotated by 180°, which doubles their
runtime.
6. Replacing the cutting blades:
■
If cutting blades have not been rotated
since the initial mounting: Rotate the
cutting
blades by 180° and insert into the
blade seat again with the sharpened side
pointing towards the appliance, and
tighten the fastening screws again by
hand.
■
If the cutting blades have already been
rotated once since the initial mounting: Insert new
cutting blades into the blade seat again with the
sharpened side pointing towards the appliance,
and tighten the new fastening screws by hand.
Note: It is only allowed to use original spare parts
from AL-KO.
In case of stubborn dirt that cannot
be removed with a brush, the blade plate must be
replaced because an imbalance can lead to
increased noise levels, greater wear and
malfunctions.
As a rule, the clearer blades do not need to be
replaced.
10 TRANSPORT
To transport the appliance, proceed as follows:
1. Stop the appliance with or the stop button.
2. Switch off the appliance with .
3. Lift the appliance with both hands on the
housing:
■
Do not touch the cutting blades.
■
The cutting blades must always point
away from the body.
11 STORAGE
11.1 Storing the automatic lawn mower The
appliance must be stored over winter or when it
is to be taken out of service for an expected
duration of longer than 30 days.
Transport
Fully charge the rechargeable battery (see
chapter 5.1 "Charging the rechargeable
battery (08)", page 50
)
2. Thoroughly clean the appliance (see chapter
9.1 "Cleaning", page 55 ).
3. Store the appliance:
■
upright on all wheels
■
at a dry, lockable location protected from
frost
■
out of the reach of children
11.2 Storing the charging pole The charging
pole must be stored over winter or when it is
expected to be out of service for an expected
duration of longer than 30 days.
1. Disconnect the power supply from the mains
supply and unplug from the base station.
2. Removing the charging pole:
■
Unscrew both screws of the charging
station (08/5).
■
Remove the charging station from the
base station by tilting.
■
Undo the plug connection of the cables
from the base station and charging
station.
■
Close the opening of the base (08/6) with
the included winter cover (08/7).
3. Storing the charging pole:
■
at a dry, lockable location protected from
frost
■
out of the reach of children
11.3 Winter storage of the boundary cable The
boundary cable can remain in the ground and
does not need to be removed.
12 DISPOSAL
Information on the German Electrical and
Electronic Equipment Act (ElectroG)
■
Electrical and electronic appliances do
not belong in household waste, but should
be collected and disposed of
separately.