AL-KO 113 365, Original Instructions For Use

Page: 36 / 192

GB
36 CS 36 Li
Operation
9 OPERATION
DANGER!
Danger of fatal injury and danger of
extremely severe injury.
Lack of knowledge of the safety instruc-
tions and operating instructions can lead
to extremely serious and even fatal in-
jury.
■
Read and follow all safety instruc-
tions and instructions for use in these
operating instructions as well the op-
erating instructions which are re-
ferred to before you start using the
chain saw.
■
Comply with working time regulations in force
in your country.
■
Grip the rear saw grip firmly with your right
hand (right-handed operator) and the front
grip with your left hand, and hold them tightly.
■
Do not release the grips for as long as the
engine is running.
■
Do not use the chain saw if you are:
■
Tired
■
Unwell
■
Under the influence of alcohol, medicines
and drugs
9.1 Determining the charge status of the
rechargeable battery (04)
There is a control panel with a pushbutton (04/1)
and LED charge status displays (04/2 to 04/5) on
the front of the rechargeable battery.
1. Press the pushbutton (04/1).
The charge status displays light according to
the charge status of the rechargeable battery.
2. To identify the charge status, see section see
chapter 9.2 "Charge status displays on the
rechargeable battery", page 36
.
9.2 Charge status displays on the
rechargeable battery
Lighting LEDs Charge status of the re-
chargeable battery
Green (04/2) The rechargeable battery is
fully charged.
Green (04/3)
and (04/4) Rechargeable battery is
charged to over 50 %.
Lighting LEDs Charge status of the re-
chargeable battery
Green (04/4) Rechargeable battery is
charged to less than 50 %.
Red (04/5) The rechargeable battery is
fully discharged or the re-
chargeable battery has been
overheated/undercooled.
9.3 Check the saw chain oil
Procedure see chapter 8.8 "Filling saw chain oil
(09)", page 35 .
IMPORTANT!
Danger of damaging the chain saw
The chain saw will be severely damaged
if there is too little or even no saw chain
oil in the tank or it has dried/is sticky.
Dried/sticky saw chain oil can lead to
damage to oil-channelling components or
the oil pump.
Damage also occurs if used oil is used.
The use of used oil leads to environ-
mental damage!
■
Each time before starting work,
check that enough saw chain oil is
present in the tank.
■
If the oil level is low, refill saw chain
oil.
■
Do not use any used oil!
9.4 Testing the chain brake
Procedure see chapter 8.5 "Testing the function
of the chain brake", page 35 .
WARNING!
Danger of fatal injury and danger of
extremely severe injury due to a de-
fective chain brake
Extremely serious injury and even fatal
injury of the operator can be caused if the
chain brake does not function, e.g. due to
kickback by the running saw chain.
■
Check the chain brake each time be-
fore starting work.
■
Do not switch the chain saw on if the
chain brake is defective. in this case,
have the chain saw checked in a cus-
tomer service workshop.