AL-KO 113 365, Original Instructions For Use

Page: 42 / 192

GB
42 CS 36 Li
Storage
7. If using the prescribed tools and the correct
handling, the specified angle values will be
obtained automatically. The values can be
checked with a chain gauge.
8. At the end, slightly round off the front part of
the depth limiter (13/2).
Sharpen the saw chain frequently, without remov-
ing much material while doing so. After sharpen-
ing 3 to 4 times yourself, have the saw chain re-
sharpened by a specialist workshop. This also in-
volves resharpening the depth limiter.
Renew the saw chain as soon as the minimum
cutting tooth length of 4 mm (13) is reached.
IMPORTANT!
Damage to the machine due to incor-
rect sharpening!
Uneven cutting teeth mean that the chain
runs roughly and may even break. All
cutting teeth must have the same length
and width after sharpening.
■
Sharpen the saw chain properly.
DANGER!
Danger of fatal injury due to kickback!
The operator can be fatally injured by
kickback of the chain saw.
■
Sharpen the saw chain properly.
12.2 Cleaning the chain sprocket interior
Thoroughly clean the chain saw after each use.
1. Remove the rechargeable battery and place
the chain saw on a stable base.
2. Unscrew the sprocket cover.
3. Clean the inside with a suitable brush.
4. Remove the saw chain and take out the
chain bar.
5. Clean the groove in the bar and the oil inlet
hole.
12.3 Changing over the quick-tension chain
wheel (16)
1. Remove the guide rail (16/1).
2. Unscrew the Phillips screw (16/3) and re-
lease the adapter sheet metal from the guide
rail with the tensioning hook (16/2).
3. Turn the guide rail around the longitudinal
axis.
4. Attach the adapter sheet metal to the chain
bar with the tensioning hook again and fix in
place with the Phillips screw again.
5. Mount the chain bar again, see chapter 7.1
"Installing the guide rail (05, 06)", page 33 .
12.4 Checking, turning and greasing the
guide rail (14, 15)
Checking the guide rail:
Regularly check the guide rail for damage. Re-
move any projecting burrs (14).
Turning the guide rail:
The chain bar must be turned over after each
chain sharpening and chain change in order to
avoid one-sided wear.
1. Change over the quick-tension chain wheel
on the guide rail, see chapter 12.3 "Changing
over the quick-tension chain wheel (16)",
page 42
.
2. Turn the guide rail.
Greasing the guide rail:
1. Carefully clean groove in bar (14/1) and oil
inlet hole (14/2).
2. Carefully clean lubricating hole (15/1) from
both sides.
3. Use a suitable grease gun to pump in suffi-
cient grease from both sides in succession
until the grease emerges evenly at the tips of
the sprocket. Keep turning the sprocket when
doing this.
13 STORAGE
Thoroughly clean the chain saw after each use.
Store it in a dry, lockable place out of the reach of
children.
Carry out the following jobs before intervals in
work lasting for longer than 30 days:
■
Switch off the chain saw and remove the re-
chargeable battery.
■
Empty the oil tank for the saw chain oil.
■
Remove the saw chain and guide rail, clean it
and spray it with rust-proofing oil.
■
Thoroughly clean the chain saw and store it
in a dry place.
IMPORTANT!
Danger of damaging the chain saw
Dried/sticky saw chain oil can lead to
damage to oil-channelling components or
the oil pump after lengthy storage.
■
Remove the saw chain oil from the
chain saw before each extended
period of storage.